Hello, I'm Christoph, Editor for Architecture on Tumblr and I'm studying Architecture in Vienna. This is my daily dose of Architecture, Art, Design, my personal work and more...
MAKE IT MODERN: DIY COLORFUL PLASTI DIP KEY TOPS
- Performix Plasti Dip Create Your Color
- Super Glue
- miniature figures or letters (I found a good selection of these at AC Moore and my local Artist & Craftsman)
- glass mixing containers (a note on that below)
- a pack of toothpicks, coffee stirrers, or small paint brushes
- a craft knife
Step 1: Figure out how you want your miniatures set on the key, and glue them on. Be careful and quick when you’re placing them – the glue dries fast and strong, so you won’t get too much of a chance to reposition anything. When considering placement, make sure you leave space for a key hole if you intend to use a key ring.
Step 2: Mix your colors – the tints are VERY heavily pigmented, so a little goes a long way. Keep in mind that less is more, and only mix a drop or two at a time. For example, I made a pretty aqua using about 2 drops of blue, 1 drop of yellow (pictured), and a drop of white. You really don’t need much. Start small and add slowly as you need.
Step 3: Here’s where the Plasti “Dip” was a little misleading. Since you’re using miniatures, you don’t actually want to dip the keys. Rubberizer is really goopy and fills in holes, so if you dip, you could end up with little blobs instead of figures or letters. Instead, use a brush or – what I ended up using – a toothpick to carefully apply the colors. If you apply too much or it hides detail around the edges, you can use a craft knife to trace around your miniature for more detail before you put on a second or third coat. It’ll look a little weird at first, but just pull off any little nubs you don’t want and it’ll work itself out after a couple more coats.
Step 4: Let the Plasti Dip dry for at least 24 hours before using, and you’re set!